Totolink ND150/ND300

Here is the guide to configure the Totolink ND150/ND300 Wireless Modem/Router
  1. Type in http://192.168.1.1 in your web browser
  2. Click on Interface Setup  on the top
  3. Virtual Circuit:  set to PVC2
    • VPI 0 / VCI 35
    • Select PPPoA/PPPoE next to Encapsulation
    • Enter your VIF Username@vif.com in the Username field
    • Enter your VIF Password
    • Next to Connection Settings choose Always on
    • Make sure the Default Route is set to YES
    • Get IP Address set to Dynamic
    • Save the settings by pressing SAVE
  4. To setup your wireless click on the Wireless Sublink under Interface Setup
    1. Enter the right country in the Channel
    2. Set Autentication Type to WPA-PSK/WPA2-PSK
    3. Use Password encryption to TKIP/AES and put in password using 8-64 characters
    4. Save the settings by pressing SAVE
  5. Next go to Advanced Setup
    1. Firewall and SPI make sure its set to Disabled
    2. Save the settings by pressing SAVE
  6. Click on Access Management then UPnP sublink
    1. UPnP and Auto-Configured make sure its set to Activated
    2. Save the settings by pressing SAVE
  7. Finally Click on Maintenance and sublink Administration
    1. put in a password to change the default admin password (this is recommended)
    2. Save the settings by pressing SAVE